DIG ML50 Guía de instalación descargar pdf (Pagina 2)

1. Connecting and installing 1/2 in. compression ﬁttings:

To install your 1/2 in. ﬁttings, cut the tubing with a hand pruner,

being careful to keep dirt from entering the line. Push the drip

tubing into the compression ﬁtting while moving it from side to side.

Option one, for planter boxes: Near the planter, connect the ½” tee and add an additional section of drip

tubing to the top of the planter. To the end of the drip tubing add a ½” elbow as well as another piece of 1/2”

tubing perpendicular to the vegetable row.

Option two, for vegetable rows: At ground level, lay out the drip tubing perpendicular to the vegetable

rows. The ½” drip tubing is used as the main line to deliver the water to the ¼” drip line, assuming you will

have a number of parallel rows with the same spacing between the rows. Make sure to extend the ½” drip

tubing a few extra feet past the last row.

Drip line layout: Lay out the ¼” drip line with drip emitters every 9” near each row of vegetables or

between two close rows (6”-10” apart) and secure to the ground using the ¼” stake included. Leave the end

of the ¼” drip line open.

1 2 3 4

Sin comentarios

DIG ML50 Guía de instalación Pagina 2