DIG ML50 Guía de instalación descargar pdf (Pagina 3)

5. Close the system:

Close the end of the 1/2 in. drip tubing by using a “ﬁgure 8” hose end and use a

goof plug to close off the end of the 1/4 in. tubing . Check to see the dripline is

operating correctly and that no leakage is occurring from the ﬁttings.

4. Flush the line:

Before turning the system on for the ﬁrst time, leave all 1/2

in. drip tubing ends and 1/4 in. dripline ends open and turn on

your water and allow it to run freely for a few minutes. This will

ﬂush out any dirt that may be in the line.

3. Secure the tubing:

Use stakes to secure the drip tubing and

dripline to the ground.

2. Connecting and installing 1/4 in. barb ﬁttings:

To install your 1/4 in. ﬁttings, cut the tubing with a hand pruner,

being careful to keep dirt from entering the line. Push the 1/4

in. dripline onto the barb ﬁtting by wiggling it as you apply

force. Next, punch a hole in the 1/2” drip tubing using the

punch and insert open end of the ¼” barb connector.

1 2 3 4

Sin comentarios

DIG ML50 Guía de instalación Pagina 3